Screw and Nut Grabber
Spring-loaded jaws grasp tiny screws
I came across this Screw and Nut Grabber ($8) in the impulse buy section during a Christmas shopping trip to a Lee Valley retail store. When I saw it sitting in the jar on the counter I hoped it was the solution to the headaches caused by my sausage fingers. At $8 it was worth the gamble. It has found itself and permanent home in my tool kit, unlike other items found in the spaces usually reserved for mints and chocolate parts.
I repair medical equipment on site for a living. While many screws are magnetic and will hold to a bit for installing upside down, I have found some manufacturers use small stainless screws to install circuit boards in devices where there is any risk of moisture ingress. This has led to me dropping many screws, accompanied by some colorful language and a scavenger hunt.
I have looked at similar devices that hold a screw onto a screwdriver but they are designed to be used for one type of screwdriver bit and I would have to carry multiple specialty drivers. This is not ideal for keeping my tool kit lightweight and portable. But this tool is small enough to fit into hard to reach areas. While not designed to allow you to apply torque it allows me to start a machine screw with little risk of cross threading then follow with a normal driver to tighten.
For starting a screw it is limited to small (~1/4″) heads or the holding prongs will slip. I have also used it for its intended purpose to the pick up dropped fuses, screws, nuts, etc.
I have used this tool for almost 2 years 3-10 times per week and it has held up very well. It is small enough to fit into any tool kit. This tool has saved me many hours of searching for dropped screws and nuts and maintain a professional demeanor at the same time.
[Amazon sells a similar tool for $7 — MF]
01/16/19Screw & Nut Grabber ($8)